Table of Contents
Advertisement
Troubleshooting—Continued
The
functions don't work
• To use
, you must make an
analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected digi-
tally (page 35).
During automatic speaker setup, measurement
fails and the message "Noise Error!" appears
• This can be caused by a speaker malfunction. Make
sure all of your speakers are working properly.
The AV receiver contains a microcomputer for signal
processing and control functions. In very rare situa-
tions, severe interference, noise from an external
source, or static electricity may cause it to lockup. In the
unlikely event that this happens, unplug the power cord
from the wall outlet, wait at least five seconds, and then
plug it back in again.
Onkyo is not responsible for damages (such as CD
rental fees) due to unsuccessful recordings caused by
the unit's malfunction. Before you record important
data, make sure that the material will be recorded cor-
rectly.
Before disconnecting the power cord from the wall out-
let, set the AV receiver to Standby.
If you use this product under direct sunlight, fluorescent
light, or germicidal lamp, ultraviolet or another elements
in the light may change the product exterior color.
• The operating instructions in this manual apply to the
iPod as of June 2007, and may change with future
upgrades to the iPod software.
• The AC adapter supplied with the DS-A1X is designed
exclusively for use with the DS-A1X. Do not use it with
another device. Likewise, do not use any other AC
adapter with the DS-A1X, including those supplied
with other RI Dock models. Doing so may damage the
AV receiver.
• If there's any noise when listening to an FM or AM
radio station on your tuner or receiver, try moving its
antenna away from the AV receiver, iPod, and AC
adapter's cable. In addition, don't wrap the AC
adapter's cable around any other cables.
connection and an
69
Advertisement
Table of Contents
