Function Overview; Basic Operation - Onkyo HT-SP904 Instruction Manual

DS-A1X RI Dock for the iPod—Continued
Putting Your iPod in the RI Dock
1. Plug in the AC adapter.
2. Turn on the AV receiver, and select the appropriate
inputs on the AV receiver.
3. Align your iPod with the RI Dock's iPod slot, and
carefully place your iPod in the slot, as shown.
Remove iPod
case before
inserting
■ Adjusting the iPod Adapter
The iPod adapter needs to be adjusted to match your par-
ticular iPod. If there's a gap between the back of your iPod
and the adapter, turn the adapter counterclockwise to close
the gap. Turning the adapter counterclockwise moves it
forward. Turning it clockwise moves it backward.
Notes:
• To prevent iPod connector damage, don't twist your
iPod when inserting or removing it, and be careful
not to knock over the RI Dock while your iPod is
inserted.
• Don't use the RI Dock with any other iPod accesso-
ries, such as FM transmitters and microphones, as
they may cause a malfunction.
Forward
Backward

Function Overview

■ Basic Operation

Note:
• The AV receiver may take several seconds to star-
tup, so you might not hear the first few seconds of
the first song.
• System On Function: When you turn on the AV
receiver, the iPod turns on as well.
• System Off Function: When you turn off the AV
receiver, the iPod turns off as well.
• Auto Power On Function
back while the AV receiver is on Standby, the AV
receiver will automatically turn on and select your iPod
as the input source. Then, your iPod will start playback.
• Direct Change Function
back while listening to another input source, the AV
receiver will automatically select your iPod as the input
source.
• Linked Dimmer Operation: When you use the AV
receiver's Dimmer function to change its display's
brightness, the brightness of the RI Dock's Power indi-
cator will change as well.
• Using the AV receiver's Remote Controller: You
can use the AV receiver's remote controller to control
basic iPod functions.
* If you use your iPod's controls to start an iPod slideshow or
video, this function will not work, so use the remote controller
instead.
Operating Notes:
• The RI Dock must be connected to the AV receiver
with both an cable and an audio cable to use the
functions.
• Before selecting a different input source, stop iPod
playback to prevent the AV receiver from selecting the
iPod input source by mistake.
• If any accessories are connected to your iPod, the AV
receiver may not be able to select the input source
properly.
• While your iPod is in the RI Dock, its volume control
has no effect. If you adjust your iPod's volume control
while it's in the RI Dock, make sure it's not set too
high before you reconnect your headphones.
*
: If you start iPod play-
*
: If you start iPod play-
47