Table of Contents
Advertisement
Advanced Setup—Continued
Equalizer Settings
These settings are set automatically by the Automatic
Speaker Setup function (see page 37).
Here you can adjust the tone of individual speakers. To
set the volume of individual speakers, see page 60.
1
Press the [RECEIVER] REMOTE
RECEIVER
MODE button, followed by the
[SETUP] button.
SETUP
2
Use the Up and Down [
buttons to select "Equalizer," and
then press [ENTER].
3
Use the Left and Right [
buttons to select:
Off: Tone off, response flat.
Audyssey: The tone for each speaker
Manual: You can adjust the equal-
If you selected Manual, continue with
this procedure. If you selected Off or
Audyssey, go to step 7.
4
Press the Down [
then use the Left and Right
[
]/[
] buttons to select a
speaker.
]/[
]
]/[
]
is set automatically by the
Automatic Speaker Setup
function. Be sure to select
this setting after having
performed the Automatic
Speaker Setup.
izer for each speaker
manually.
] button, and
5
Use the Up and Down [
buttons to select a frequency.
Use the Left and Right [
buttons to adjust the level at that
frequency.
The volume at each frequency can be
adjusted from –6 to +6 dB in 1 dB
steps.
Tip: Low frequencies (e.g., 80 Hz)
affect bass sounds; high frequencies
(e.g., 8000 Hz) affect treble sounds.
6
Use the Up [
"Ch," and then use the Left and
Right [
another speaker.
Repeat steps 5 and 6 for each speaker.
Speakers that you've set to No or None
in the Speaker Configuration (page 57)
cannot be selected.
7
Press the [SETUP] button.
The setup menu closes.
SETUP
Notes:
• The front, center, and surround speakers can be
adjusted at 80 Hz, 250 Hz, 800 Hz, 2500 Hz, and 8000
Hz. The subwoofer can be adjusted at 40 Hz, 80 Hz,
and 160 Hz.
• While the Direct listening mode is selected, the equal-
izer settings have no effect.
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
]/[
]
]/[
]
] button to select
]/[
] buttons to select
61
Advertisement
Table of Contents
