Table of Contents
Advertisement
St e p 3 : Pre se t t ing ra dio
st a t ions (c ont inue d)
T o t une in a st a t ion w it h a w e a k
signa l
Press m or M repeatedly in step 2 to tune in
the station manually.
T o se t a not he r st a t ion t o a n
e x ist ing pre se t num be r
Start over from step 1. After step 5, press . or
> to select the preset number where you want
to store the other station, then press PUSH
ENTER.
You can preset a new station in the selected preset
number.
T o e ra se a pre se t st a t ion
1 Press TUNER/BAND repeatedly to select FM
or AM.
2 Press MODE SELECT repeatedly to select
"Set Up Mode", then press PUSH ENTER.
3 Move the multi stick toward b or B repeatedly
to select "TUNER Set Up ?", then press PUSH
ENTER.
4 Move the multi stick toward b or B repeatedly
to select "TUNER Erase ?", then press PUSH
ENTER.
5 Move the multi stick toward b or B repeatedly
to select the preset number you want to erase,
then press PUSH ENTER.
Select "TUNER Ers FM ALL" (or "TUNER
Ers AM ALL") when you want to erase all the
preset stations.
When you erase a preset number, the preset
number decreases by one and all preset numbers
following the erased one are renumbered.
T ip
The preset stations are retained for half a day even if
you unplug the power cord or a power failure occurs.
10
Downloaded from:
https://www.usersmanualguide.com/
T o c ha nge t he AM t uning
int e rva l
(Ex c e pt for t he Europe a n m ode l)
The AM tuning interval is factory-preset to 9 kHz
(10 kHz in some areas). To switch the AM tuning
interval, tune in any AM station first, then turn off
the power. While holding down MODE SELECT,
turn the power back on. When you switch the
interval, AM preset stations are erased. To switch
back to the original interval, repeat the same
procedure.
Advertisement
Table of Contents
