Hearth & Home IntelliFire Plus RC300-MON-VFL Operating Instructions

IntelliFire Plus™ Multifunction Remote Control
NOTE: For additional information, refer to the RC300-MON-
VFL Installation and Operating Instructions or visit www.
fireplaces.com/rc300demo to view the RC300 demo video.
Display Screen
APPLIANCE STATUS
THERMOSTAT
FLAME HEIGHT
TIMER DISPLAY/FUNCTION
Figure 1. RC300 Display Screen
Function Buttons
Use POWER button to turn the appliance on
and off.
Menu
Use MENU button to display the menu functions.
Menu
Only functions that can
V
Select
displayed. For example: Flame Height will not
V
Select
be displayed when the remote status is OFF.
Menu
Use the SELECT button to select the current
V
Select
feature.
Use the UP and DOWN arrows to toggle
through the menu functions and value selec-
V
V
tions in the submenus.
Idle When Remote is in ON Mode
The remote control will go into an idle mode if no but-
tons are pressed within 5 seconds. Press any button to
resume full functionality. In idle mode only active func-
tions will show on the screen.
Hearth & Home Technologies • RC300-MON-VFL Multifunction Remote Control Operating Instructions • 4018-901 Rev. B • 01/21
RC300-MON-VFL
Operating Instructions - Quick Reference Guide
THERMOSTAT DESIRED
TEMP SETTING
CHILD LOCK
INDICATOR
TRANSMISSION
INDICATOR
LOW BATTERY
INDICATOR
ROOM TEMP
DISPLAY
be activated will be

Standby mode

The remote control will go into a standby mode if no but-
tons are pressed within 5 minutes. Press the POWER
button to reactivate the remote control to ON mode. Ac-
tive functions will be displayed

About ON Mode

• All functions can be accessed when the remote control
is in the ON mode.
• Only active functions will be displayed when the remote
control is in the ON mode.

Turning On the Appliance

• Press the POWER button to turn the appliance ON. The
appliance will first ignite the pilot. Once the pilot flame is
established the main burner will be lit.
NOTICE: Whenever the appliance is cycled from OFF to
ON, the main burner will light on high for 10 seconds before
returning to the previous user setting.

Adjusting Flame Height

• Press the MENU button to activate the menu.
• Using the UP and DOWN arrows highlight the FLAME
icon and press SELECT.
• Use the UP and DOWN arrows to adjust the FLAME
HEIGHT, then press SELECT. The FLAME HEIGHT
can be adjusted to 5 different settings.
NOTICE: FLAME HEIGHT will not be adjustable for first
ten seconds when appliance is turned on.
NOTICE: The system will remember the previous FLAME
HEIGHT setting and will automatically adjust after 10
seconds.
NOTICE: Some models use fixed valves, which cannot
be adjusted.
Menu
V
Select
1