Table of Contents
Advertisement
Note 2
When any of these Flexible Boards is peeled off and
decreased adhesive force of the Adhesive Part or wrinkle or
break of the Flexible Board is found, replace the defective
Flexible Board with a new one.
これらのフレキシブル基板を剥がした場合に， 粘着部の粘
着力の低下， フレキシブル基板のしわ， 折れが認められた
場合は新品に交換してください。
Note 3
Cut the SHEET, ADHESIVE (4-441-672-01) as shown in the
balloon in the figure and use it.
SHEET, ADHESIVE (4-441-672-01) は図中の吹き出しのように
切って使用すること。
Notes on Assembling the Lens Section-2
How to distinguish the side of Optical Filter Block facing to Lens Device
The one side of the Optical Filter Block has treated with IR cut coating.
Mount the Optical Filter Block facing the IR cut coated side to the lens
device. Distinguish the IR cut coated side from the other by applying the
fluorescent light to the Optical Filter Block in the dark place (cut off the
outside light).
Optical Filter Block
Hold it with tweezers or the like.
[IR Cut Coated Side]
Lens Device side
• IR cut coating surface
The red coating is reflected.
HDR-CX620/HDR-CX670/HDR-PJ620/HDR-PJ670
[The Other Side]
• The other surface
The red coating is
• Side view
not reflected.
The red belt
is seen.
Lens Device side
4-10
Advertisement
Table of Contents
