Table of Contents
Advertisement
11. Install the Frame (F-SUB-A), Frame (F-SUB-B), and Ball Bearing while attaching the four bosses and the shaft,
and then tighten five screws in the order as shown in the figure below.
Tightening torque = 0.18 ± 0.02N · m (1.8 ± 0.2kg f · cm)
Screws
P
T O
Motor B
Boss
Shaft
Frame (F-SUB-B),
Ball Bearing
12. Pass the FP-2189 Flexible Board through the F-SUB-B hole and stick the Adhesive Part. If the adhesive force is
lowered, cut the Adhesive Sheet as shown in the figure in the frame and then stick it.
P
T O
Shape and sticking position
of Adhesive Sheet
Adhesive
part
HDR-CX620/HDR-CX670/HDR-PJ620/HDR-PJ670
Boss
Bosses
Frame (F-SUB-A)
Adhesive part
FP-2189
Flexible Board
FP-2189
Flexible Board
Screws
4-38
Advertisement
Table of Contents
