E-Software Upgrades - BIO-MED DEVICES CROSSVENT-3+ Operation & Service Manual

IX. MAINTENANCE AND SERVICE- cont.
E E E E - - - - SOFTWARE UPGRADES SOFTWARE UPGRADES
SOFTWARE UPGRADES SOFTWARE UPGRADES
RS-232 COMPUTER INTERFACE - A 6 pin, modular jack is provided as a convenient PC interface for
software updates. It is located in the rear of the unit behind the rear panel.
On occasion, software upgrades may be released with further enhancements to the Crossvent. These are
available through Bio-Med Devices or your dealer. It is a rather simple task to install new software into the
Crossvent, but this should be done by qualified personnel as the rear panel of the ventilator must be
removed to access the RS232 jack used to download the software.
When requesting new software, the serial number of the Crossvent is required. Each software download is
defined for a specific Crossvent, identified by its serial number. Without the proper serial number, the
software will not load.
When ordering software, use part #PRT4427C.
adapter to connect it to a computer are included. This adapter is custom and may not be substituted. Keep
this cable and adapter in a safe place for future use. If you have these, then often times any future software
upgrades can be emailed.
Along with the software, a communication cable and
51 51
51 51