Page 2
Step 4 - Finally, connect the power cord to the 360 PoE Injector and power on the device. The Green Power LED will indicate the unit is receiving power. Once the injector is powered on, the 865W PRO CPE should have PoE power over the Interlink Ethernet cabling. The Green Power LED on the CPE should now be lit.
Page 3
PRO CPE LAN 1 and LAN 2 PoE ports and test connectivity. Active PoE is output on both LAN 1 and LAN 2 on the 865W PRO CPE so do not connect a non-PoE device to these ports. Enable-IT can modify the LAN / PoE output ports on the 865W CPE unit at time of order.
Page 4
First examine the backbone wiring pair and make sure you have solid connections. The Interlink Sync LED will be lit solid Green with rapid pulsing on each 865W PRO unit to show proper connection and pairing. If the Interlink Sync LED Link is flashing slow to fast and never goes solid…. Then follow...
Page 5
Online Technical Services The Enable-IT Support Portal is available 24/7 to open a ticket or check the status of one. Please use this support website as your first source for help as it contains an on-line knowledge base of articles, documentation, FAQ's and other problem-solving resources.
Page 6
Remedies for Breach of Warranty. In the event of a breach of the foregoing warranty, Enable-IT will, in its sole discretion and at its cost, and subject to the terms of the following paragraph, repair the non-conforming Product, replace the non-conforming Product with a new or reconditioned Product or refund the purchase price for the Product.
Page 7
USING THE PRODUCT. 2. LIMITATION OF LIABILITY. IN NO EVENT SHALL ENABLE-IT BE LIABLE TO THE END USER, OR ANY THIRD PARTY, FOR ANY INDIRECT, SPECIAL, PUNITIVE, INCIDENTAL OR CONSEQUENTIAL DAMAGES IN CONNECTION WITH OR ARISING OUT OF THE SALE OR USE OF THE PRODUCT (INCLUDING...
Need help?
Do you have a question about the 865W PRO and is the answer not in the manual?
Questions and answers