Hobo MicroRX RX210 Series Installing

Hide thumbs Also See for MicroRX RX210 Series:

Installing a Micro SIM Card in a HOBO® MicroRX (RX210x) Station

Requirements:

• HOBO RX2100 MicroRX Station

• USB cable

• One of the following:

 HOBOconnect version 1.5 or higher

 HOBOware® version 3.7.23 or earlier

• User-provided data plan and SIM requirements:

 Micro SIM for 4G LTE Network; supports UMTS/HSPA+ at 800, 850, 900, 1800, 1900, or 2100 MHz and LTE at 700,

800, 850, 900, 1800, 1900, 2100, or 2600 MHz

 The SIM must already be activated and unlocked.

 APN for the associated carrier

1. Make sure the station is powered down. Unplug the battery cable and the solar panel cable and AC adapter (if

applicable).

Battery disconnected;

no charging device

plugged in

2. Carefully slide the micro SIM card into the SIM port and gently push it into place (it makes an

audible click when it is properly seated).

23845-E

Table of Contents

Do you have a question about the MicroRX RX210 Series and is the answer not in the manual?

Page 1 Installing a Micro SIM Card in a HOBO® MicroRX (RX210x) Station Requirements: • HOBO RX2100 MicroRX Station • USB cable • One of the following:  HOBOconnect version 1.5 or higher  HOBOware® version 3.7.23 or earlier • User-provided data plan and SIM requirements: ...
Page 2 Installing a Micro SIM Card in a HOBO MicroRX (RX210x) Station Micro SIM installed 3. Plug in the battery and any charging device (if applicable). The LCD displays the message Initializing System while the system powers up. Wait until you see a checkmark next to System.
Page 3 Under Cellular Configuration, enter the APN for the SIM card. You can also enter a username and password. If you are using HOBOware: 1. Open HOBOware. 2. From the Device menu, select Manage RX Station. Note for Windows: You may see a warning that Windows Firewall has blocked some features.
Page 4 8. Once the LCD is blank, plug in the battery and any charging device (if applicable). The LCD displays the message Initializing System while the system powers up. Wait until you see a checkmark next to System. Your station should now be ready to connect with HOBOlink®.

Microrx rx2100