Table of Contents
Advertisement
Installing Your Dimmers
Installing an AuroRa dimmer is as straightforward as replacing a light switch.
Your first step is to identify how many switches control the lights you
have decided to add to your system.
This is important so that you use the correct installation instructions.
Lutron has created specific instructions for lights controlled by one, two,
or three switches to help simplify your installation.
After you have installed the first dimmer, repeat the process until all of the
AuroRa dimmers have been installed.
Note:
If this is your first time wiring a dimmer, we recommend that you read over
the dimmer information found on page 18 before proceeding. If you have any
questions, give our 24/7 Technial Support Center a call at 800.523.9466.
Use dimmers with 120V incandescent lighting fixtures only. Do not use
with low-voltage transformers.
The total wattage of all light bulbs controlled by each dimmer must be
between 50 and 600 watts.
When combining dimmers in the same wallbox, the dimmer's load capacity
must be reduced.
Page 4
Need help? Call the Lutron Technical Support Center, 24/7 at 800.523.9466
Advertisement
Table of Contents
