Table of Contents
Advertisement
Adding to Your System
Activating Additional Wireless Controllers
Before additional wireless controllers can be used to control
lights in the AuroRa
Follow the steps below to activate a wireless controller.
1
Enter Advanced "Add" Mode
Press and hold the "Add" button on the
central antenna until the LED light begins to
flash (approximately 3 seconds).
Dimmers that are in the system will flash
the lights connected to each. The master
control will flash the LEDs corresponding to
dimmers present in the system.
2
Activate Wireless Controller
Press and hold any button on the wireless
controller until the "Visor" LED light on the
central antenna starts flashing
(approximately three seconds), indicating
the wireless controller has been activated
in the system. The "Add" LED and the
"Visor" LED will remain flashing until the
wireless controller button is released.
3
Exit Advanced "Add" Mode
Press and hold the "Add" button until the
"Add" LED light stops flashing and remains
off (approximately 3 seconds).
The dimmers will stop flashing their lights.
The wireless controller has now
4
been activated.
Page 16
Need help? Call the Lutron Technical Support Center, 24/7 at 800.523.9466
system, they must be activated.
®
RF Communication
System
Visor
Advanced
Bridge
Add
Power
RF Communication
System
Visor
Advanced
Bridge
Add
Power
RF Communication
System
Visor
Advanced
Bridge
Add
Power
Advertisement
Table of Contents
