Adding To Your System - Lutron Electronics AuroRa Installation Manual

Adding to Your System

Bridging AuroRa
1
Purchase and install two separate AuroRa systems.
2
To bridge two systems, press and hold the "Bridge"
button on the central antenna of either system for 3
seconds. The "Bridge" LED should flash slowly.
3
Press and hold the "Bridge" button on the second
central antenna for 3 seconds. The "Bridge" LED
should flash slowly.
The LEDs on both central antennas will begin to
flash quickly as the bridging process starts.
The loads in both systems will start flashing.
4
When the process is finished, the "Bridge" LEDs on
both central antennas will stop flashing and stay
on. The loads in both systems will stop flashing.
5
The systems are now bridged.
For information about returning your system to its
?
original default settings, visit www.lutron.com/aurora.
Bridged System Functionality
"All On" Button
All dimmers in both systems will turn on to full brightness.
"All Off" Button
All dimmers in both systems will turn off.
"Favorite" Button
All dimmers in both systems will turn on to their
local slider levels.
Need help? Call the Lutron Technical Support Center, 24/7 at 800.523.9466
Systems
®
The central antennas should be at least
3 feet apart and within 60 feet of each
other when bridging two systems.
RF Communication
System Visor
Advanced
Bridge Add
Power
RF Communication
System Visor
Advanced
Bridge Add
Power
RF Communication
System Visor
Advanced
Bridge Add
Power
RF Communication
System Visor
Advanced
Bridge Add
Power
Rooms
Fr Entry
Grge Ext
Foyer
Kitchen
Family
All On All Off
All On All Off Favorite
RF Communication
System Visor
Advanced
Bridge Add
Power
RF Communication
System Visor
Advanced
Bridge Add
Power
RF Communication
System Visor
Advanced
Bridge Add
Power
RF Communication
System Visor
Advanced
Bridge Add
Power
Page 15