Table of Contents
Advertisement
7.
If the configuration of the hard disk you are installing does
not match one of the drive types listed in Appendix F,
highlight User defined and press Enter. You
following:
The same parameter is highlighted on the submenu above.
Enter the correct number of cylinders (tracks) for the disk
and press Enter.
The information for Number of cylinders is
automatically updated on the submenu above and you see
the next parameter, Number of heads. Enter the
correct number of read/write heads for the hard disk and
press Enter.
Follow this same procedure for each remaining item in the
settings list (the number of sectors, the precompensation
cylinder, and the landing zone).
If you enter a parameter incorrectly, press
highlight the parameter and then enter it again.
The Setup program does not allow you to enter the total
storage capacity; it calculates the storage capacity for you,
based on what you enter for the number of cylinders, heads,
and sectors.
After you type the landing zone number and press Enter,
the cursor block returns to the Drive submenu heading.
2-26
Running the Setup Program
see the
or
to
Advertisement
Table of Contents
