Table of Contents
Advertisement
You can change the angle of the keyboard by adjusting the legs
on the bottom. Turn the keyboard over and lift each leg upward
until it locks into place, as shown below. You can lock the legs
to a low or high position, or leave them flat.
7
Turning On the Computer
After you set up your system, you're ready to turn on the power.
But first, read the following safety rules to avoid accidentally
damaging your computer or injuring yourself:
Never turn on the computer with a protector card in the
diskette drive.
Do not dismantle any part of the computer. Only remove
the cover to access optional devices or change jumper or
DIP switch settings. If there is a hardware problem you
cannot solve after reading the troubleshooting information
in Appendix B, contact your Epson dealer.
Always turn off the power, disconnect the computer's
power cord, and wait five seconds before you remove the
computer's cover.
Do not unplug cables from the computer when the power
is on.
1-16
Setting Up Your
System
Advertisement
Table of Contents
