Epson Equity 386/25 User Manual page 173

See "Adding Memory Modules" in Chapter 5 for more
information about the possible SIMM configurations in the
Equity 386/25.
The following table describes DIP switches 8 through 10.
Other DIP
If you need to check or change any DIP switch settings, follow
these steps in the order listed here as necessary for your system:
Follow the instructions in "Removing the Cover" in
Chapter 5 to remove the computer's cover.
To change DIP switch settings, you need to remove the SPF
card first. See "Removing the SPF Card" below for instructions.
Once the SPF card is removed, you can check or change the
DIP switch settings. See "Setting the DIP Switches" later in
Replace the SPF card you removed to access the DIP
switches. Follow the instructions in "Replacing the SPF
Then follow the instructions in "Replacing the Cover" in
Chapter 5 to replace the computer's cover.
A-8 Changing Jumper and
switch settings
DIP Switch Settings