Chapter 11 Hardware Design - Ebyte E29-T Series User Manual

Chengdu Ebyte Electronic Technology Co., Ltd.
In the configuration on computer, the module address, Channel, network ID, and key are all in decimal. The range of values of

each parameter is:
Network address: 0～65535
Channel：0～83
Network ID：0～255
Key：0～65535
When user configures the repeater mode using the host computer, one point much be paid attention to: In the configuration

software, each parameter is in decimal, so the module address and network ID need to be converted when set it.
 For example, in the configure software, if the network ID of Transmitter A is input 02, and the network ID of Receiver B is input
10, then the module address of Repeater R should be set as 522. (The address of Repeater R is 0X020A in hex, and it need to be
converted to decimal. )

Chapter 11 Hardware design

It is recommended to use a DC stabilized power supply. The power supply ripple factor is as small as possible,

and the module needs to be reliably grounded.；
Please pay attention to the correct connection of the positive and negative poles of the power supply. Reverse

connection may cause permanent damage to the module；
Please check the power supply to ensure it is within the recommended voltage, otherwise, the module will be

permanently damaged when it exceeds the maximum voltage；
Please check the stability of the power supply, the voltage can not be fluctuated frequently；

When designing the power supply circuit for the module, it is often recommended to reserve more than 30% of

the margin, which is beneficial for long-term stable operation of the whole machine ;
The module should be as far away as possible from the power supply, transformers, high-frequency wiring and

Copyright ©2012–2023，Chengdu Ebyte Electronic Technology Co.,Ltd.
E29-400TXXX product data sheet
24