Table of Contents
Advertisement
Setting the Jumpers
To change a jumper setting, follow these steps:
1. Refer to the illustration on page 4-6 to locate the jumpers.
2. If any option cards are installed in your computer, you may
need to remove them to access the jumpers; see page 4-18.
3. A jumper's setting is determined by where the jumper is
placed on the pins. Use the table below to identify the pin
settings for 2-, 3-, and 4-pin jumpers. (To identify the pin
numbers, look at the system board under the jumper.)
Jumper positions
To move a jumper from one position to another, use
needle-nose pliers or tweezers to pull it off its pins and
gently move it to the desired position.
Installing and Removing Options 4-9
Advertisement
Table of Contents
