Table of Contents
Advertisement
Software Problems
Windows won't start after you installed the lDE drivers
Reinstall the IDE drivers, making sure you load the driver for
DOS as well as for Windows.
The application program does not statt.
Check that you are following the correct procedure for starting
the program and that it is installed correctly. If you do not have
a hard disk, make sure the correct diskette is in the diskette
drive. If you need help, contact your software manufacturer.
The application program cannot read a key disk.
You may be running an application that requires a slower
processor speed. Change the processor speed using a keyboard
command, as described in Chapter 3.
The application program cannot read from or write to the
hard disk drive.
If you have enabled the Fixed Disk Timeout option in
SETUP, your application may be timing out during the few
seconds when the hard disk drive returns to its full speed.
Disable this option in SETUP as described in Chapter 2.
Your application has locked the computer, making it
unresponsive to keyboard commands
Reset the computer and try again. If resetting the computer
does not help, turn it off, wait 20 seconds, then turn it on again.
Some software, like OS/2,
8MB to 16MB of RAM to work correctly. Check your software
documentation for the minimum memory requirements. If
necessary, add more memory as described in Chapter 4.
®
®
U N I X ,
or NetWare,
®
needs at least
Troubleshooting
6-11
Advertisement
Table of Contents
