Table of Contents
Advertisement
System
configuration:
MS-DOS version:
Software versions:
CONFIG.SYS:
AUTOEXEC.BAT:
The Computer Will Not Start
The power light is on, but the computer does not start.
Make sure the boot options in SETUP are set to access drive A,
as described in Chapter 2. Then place a bootable diskette in
drive A and turn on the computer again.
Caution
If you turn off the computer, always wait at least 20 seconds
before turning it back on to prevent damage to its circuitry.
Troubleshooting
6-2
Start SETUP and make a note of all
your configuration option settings.
At the MS-DOS prompt, type
and press Enter.
In Windows applications, select
About from the Help menu. As
your software application starts, it
usually displays a version number
on the banner screen. Also, you can
check your software manual.
At the MS-DOS prompt, type
: \
T Y P E C
C O N F I G
Enter to see a listing of your
CONFIG.SYS file, which contains
system configuration commands.
At the MS-DOS prompt, type
C:\AUTOEXEC.BAT
TYPE
press Enter to see a listing of your
AUTOEXEC.BAT file, which
contains system startup commands.
V E R
.
a n d p r e s s
S Y S
and
Advertisement
Table of Contents
