Maintenance - MULTIQUIP Mikasa Series Operation Manual

DAILY
„ Thoroughly remove dirt and oil from machine.
„ Make sure that all bolts and nuts are not loose. If they
are loose, retighten them to avoid any accidents.
„ Retighten all nuts for assembling foot.
„
OIL REPLACEMENT
„ Remove the oil drain plug (Figure 11) on foot housing
and drain the main body oil.
„ Refill the main body oil from the oil inlet plug on the
protection sleeve on level ground. Fill to the edge of the
oil inlet hole with the recommended oil type.
Figure 11. Oil Drain Plug
MTe55 RAMMER • OPERATION MANUAL — REV. #1 (12/15/22) — PAGE 19
CLEANING
Do not use a hose or pressure washer to spray water on
the DC Power Unit and Battery Pack while cleaning them.
Water entering the components may cause a malfunction.
STORAGE
1. Stop the DC Power unit before storing the machine.
2. Do not move the machine until the DC Power Unit and
main body have cooled down enough.
3. Remove the battery pack.
4. Avoid storage areas with high temperature and high
humidity, or environments with severe temperature
changes.
5. Keep away from direct sunlight and rain.
6. Put a cover on the machine to avoid exposure to dirt.

MAINTENANCE