Maintenance - MULTIQUIP Mikasa Series Operation And Parts Manual

DAILY
DAILY
„ Thoroughly remove dirt and oil from the engine and
Thoroughly remove dirt and oil from the engine and
control area.
control area.
„ Clean or replace the air cleaner elements as necessary.
Clean or replace the air cleaner elements as necessary.
Check and retighten all fasteners as necessary.
Check and retighten all fasteners as necessary.
„ Check the spring box and bellows for oil leaks. Repair
Check the spring box and bellows for oil leaks. Repair
or replace as needed.
or replace as needed.
EVERY 50 HOURS
EVERY 50 HOURS
„ Remove and clean the spark plug, then adjust the spark Remove and clean the spark plug, then adjust the spark
gap to 0.024~0.028 inch (0.6~0.7 mm).
gap to 0.024~0.028 inch (0.6~0.7 mm).
EVERY 80 TO 100 HOURS EVERY 80 TO 100 HOURS
Remove the air cleaner cover. Loosen and remove
„ Remove the air cleaner cover. Loosen and remove
the 2 screws that hold the cover to the air cleaner
the 2 screws that hold the cover to the air cleaner
assembly. If the primary element (Figure 11) is dirty,
assembly. If the primary element (Figure 11) is dirty,
wash it with gasoline or kerosene. Then dip it in engine
wash it with gasoline or kerosene. Then dip it in engine
oil (SAE10W-30) and wring the element so that 25 to 30
oil (SAE10W-30) and wring the element so that 25 to 30
cc of engine oil remains on the element.
cc of engine oil remains on the element.
Figure 11. Air Cleaner Primary Element
EVERY 200 HOURS
Figure 11. Air Cleaner Primary Element
Remove the oil drain plug on foot housing (Figure 12) and
EVERY 200 HOURS
drain the oil. Refill with approximately 1.4 pint (650 cc)
of 10W-30 SE, SF or higher grade motor oil. Oil should
„ Remove the oil drain plug on foot housing (Figure 12) and
be midway in sight glass. Break in oil should be changed
drain the oil. Refill with approximately 1.4 pint (650 cc)
after first 50 hours.
of 10W-30 SE, SF or higher grade motor oil. Oil should
OIL FILL PLUG
be midway in sight glass. Break in oil should be changed
after first 50 hours.
SIGHT GLASS
OIL DRAIN PLUG
OIL FILL PLUG
SIGHT GLASS
OIL DRAIN PLUG
Figure 12. Oil Drain Plug
MTX60SF RAMMER • OPERATION AND PARTS MANUAL — REV. #0 (03/01/13) — PAGE 17
Figure 12. Oil Drain Plug
MTX60SF RAMMER • OPERATION AND PARTS MANUAL — REV. #1 (06/21/19) — PAGE 17
PRIMARY
ELEMENT
PRIMARY
ELEMENT
EVERY 6 MONTHS
EVERY 6 MONTHS
„ Clean the inside of the fuel tank with solvent.
Clean the inside of the fuel tank with solvent.
„ Inspect and clean fuel strainer (Figure 13). Replace
Inspect and clean fuel strainer (Figure 13). Replace
strainer if necessary.
strainer if necessary.
Figure 13. Fuel Strainer
Figure 13. Fuel Strainer
EVERY 2 YEARS
EVERY 2 YEARS
Replace the fuel line every 2 years even if there is no
visible damage.
„ Replace the fuel line every 2 years even if there is no
LONG TERM STORAGE
visible damage.
LONG TERM STORAGE Slide the throttle lever to the STOP position.
Drain any fuel including in the fuel hose.
„ Slide the throttle lever to the STOP position.
Replace lubrication oil and apply grease to lubrication
„ Drain any fuel including in the fuel hose.
points.
„ Replace lubrication oil and apply grease to lubrication
Cover the air intake on the air cleaner and the exhaust
points.
outlet on the muffler.
Store unit indoors covered with plastic sheet in moisture
„ Cover the air intake on the air cleaner and the exhaust
free and dust free location out of direct sunlight.
outlet on the muffler.
„ Store unit indoors covered with plastic sheet in moisture
free and dust free location out of direct sunlight.

MAINTENANCE

MAINTENANCE
FUEL FILTER