To change the length of the label:
1. Press the LABEL key.
2. Select Length, then Fixed. Length is not available if you are using a pre-sized label supply.
3. Enter the desired length of the label into the field.
4. Press
Note: The minimum and maximum values for the label supply installed are shown to the left and
right of the type-in field.
Go to Label or Area
To move to another label:
1. Press the LABEL key.
2. Select Go to, then enter the number of the label desired.
3. Press
To move to another area on a label with multiple areas:
Note: Areas can only be used on continuous label supply.
1. Press FN and AREA keys.
2. Select Go to, then enter the number of the area desired.
3. Press
Shortcut Keys
•
Press NEXT LABEL to go to the next label in the file.
•
Press FN and PREV LABEL to go to the previous label in the file.
•
Press NEXT AREA to move to the next area within a label with multiple areas configured.
•
Press FN and PREV AREA to move to the previous area within a label with multiple areas
configured.
•
Use the FN key plus navigation keys. See
page
Shortcuts on the Touchscreen
Scroll through labels or areas by tapping the upper right corner to access the scroll arrows on the
screen.
•
Use the up and down arrows to access the next or previous label in the sequence.
•
Use the right and left arrows to access the next area in the sequence.
M710 User Manual
.
.
.
31.
"Move to an area" on page 30
Editing Labels on the Printer
Labels and Areas
and
"Move to a label" on
44