Regulatory And Warning Statements - Cobra 75 All Road Owner's Manual

Regulatory and Warning Statements

Intro Operation
Intro Operation Customer Warranty
Assistance
FCC Part 15.19 Warning Statement
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE
Customer
Installation
Installation
Assistance
MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
Secondary Icons
Secondary Icons
FCC Part 15.21 Warning Statement-
NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY
APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER'S Notice
Notice Caution Warning
AUTHORITY TO OPERATE THE EQUIPMENT.
FCC Part 15.105(b) Warning Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
-
- Increase the separation between the equipment and receiver.
-
- Connect the equipment into an outlet on a circuit different from that to which the receiver
-
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
-
IC RSS-GEN, Sec 8.4 Warning Statement
ENGLISH: This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
FRENCH: Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
22
Customer Warranty
Assistance
Customer
Assistance
Caution Warning
Regulatory and Warning Statements
IC RSS-GEN, Sec 8.3 Warning Statement
ENGLISH: This radio transmitter (identify the device by certification number, or model number if Category II)
has been approved by Industry Canada to operate with the antenna types listed below with the maximum
permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included
in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use
with this device.
Immediately following the above notice, the manufacturer shall provide a list of all antenna types approved for
use with the transmitter, indicating the maximum permissible antenna gain (in dBi) and required impedance
for each.
FRENCH: Le présent émetteur radio (identifier le dispositif par son numéro de certification ou sonnuméro de
modèle s'il fait partie du matériel de catégorie I) a été approuvé par Industrie Canada pour fonctionner
avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise
pour chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au
gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.
RF Exposure Statement
ENGLISH: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 40cm between the
radiator & your body.
The device is in compliance with RF exposure guidelines, users can obtain Canadian information on RF
exposure and compliance. The minimum distance from body to use the device is 40cm.
FRENCH: Cet équipement est conforme aux limites d'exposition aux rayonnements de la FCC établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 40 cm
entre le radiateur et votre corps.
Après examen de ce matériel aux conformité ou aux limites d'intensité de champ RF, les utilisateurs peuvent
sur l'exposition aux radiofréquences et compliance d'acquérir les informationscorrespondantes. La distance
minimale du corps à utiliser le dispositif est de 40cm.
Product Exposure Statement
ENGLISH: Warning: The 75 All Road CB radio is for in-vehicle use only. It is not to be installed outside the
intended vehicle of use. This includes the installation and operation of third-party Bluetooth devices such as
a compatible headset paired and connected to the 75 All Road CB radio. Long term operation outside the
vehicle may result in damage to the 75 All Road CB radio.
FRENCH: Avertissement : La radio 75 All Road CB est destinée à une utilisation en véhicule uniquement.
Il ne doit pas être installé en dehors du véhicule d'utilisation prévu. Cela inclut l'installation et le
fonctionnement d'appareils Bluetooth tiers tels qu'un casque compatible couplé et connecté à la radio
75 All Road CB. Une utilisation à long terme à l'extérieur du véhicule peut endommager la
radio 75 All Road CB.
23