Customer Assistance; Installation; Customer; Assistance - Cobra 19 DX IV EU Owner's Manual

Main Icons
y n t r a a r W e r m o s t u C n i o a t e r p O o t r I n
e c n a i s t s s A
Operating Your Mobile Radio
s n o I c n a i M
Intro

Operation

Operation
e r m o s t u C
n i o a t a l l s t I n
e c n a i s t s s A

Antenna Connector

Installation

s n o I c y a r d n o c e S
y n t r a a r W e r m o s t u C n i o a t e r p O o t r I n
Secondary Icons
e c n a i s t s s A
g n n i a r W n i o u t a C e i c o t N
Main Icons
e r m o s t u C

Notice

n i o a t a l l s t I n
e c n a i s t s s A
External Speaker Jack
s n o I c y a r d n o c e S
Intro Operation
g n n i a r W n i o u t a C e i c o t N
s n o I c n a i M
Power Cable Installation
Secondary Icons
y n t r a a r W e r m o s t u C n i o a t e r p O o t r I n
e c n a i s t s s A
Notice
e r m o s t u C
n i o a t a l l s t I n
e c n a i s t s s A

Microphone Connector

s n o I c y a r d n o c e S
g n n i a r W n i o u t a C e i c o t N
English
4
19DXIVEU_MANL_ENG_vL.indd 4-5
Operation

Customer

Warranty

Assistance

Antenna Connector
Customer
This female Connector on the rear panel permits
Assistance
connection of the transmission line cable male
con nec tor to the transceiver.
Caution Warning
External Speaker
The jack on the rear panel is used for an External
Speaker. The external speaker should have 8­ohm
impedance and be rated to handle at least 4.0 watts. When
Customer Warranty
the external speaker is plugged in, the internal speaker is
Assistance
automatically disconnected.
Customer

Power

Assistance
These wires supply Power to the CB radio.
This cable is permanently attached to the radio.
Caution Warning
Microphone Connector
Allows for convenient removal of the Microphone when
storage is required. The Microphone MUST be connected
to the unit at all times, when in use, for proper operation.
Main Icons
Main Icons
Operating Your Mobile Radio
Intro Operation Intro Operation
Operation
•
Before using this radio, please check that the radio has been programmed on the
Installation
frequency band specifications and operating modes allowed by the regulations valid in the
Installation
country where the product is used. If not, please proceed to modify the frequency band
Secondary Icons
s n o I c
Secondary Icons
programming, as described below. This radio is programmed at the factory on the EU
frequency band (40 CH AM 4W/40 CH FM 4W).
Main Icons
On-Off/Volume Knob
Notice
y n t r a a r W e r m o s t u C n i o a t e r p O o t r I n
e c n a i s t s s A
Intro Operation
e r m o s t u C
n i o a t a l l s t I n
e c n a i s t s s A
CH9/Normal/CH19 Button
s n o I c y a r d
Installation
Secondary Icons
g n n i a r W n i o u t a C e i c o t N
Channel Selector Knob Notice

CB Antenna

Only a properly matched Antenna system will allow maximum power output. In mobile
installations (cars, trucks, boats, etc.), an Antenna system that is non­directional should be
used. When installed in a boat, the transceiver will not operate at maximum efficiency without
a ground plate unless the vessel has a steel hull. Before installing the transceiver in a boat,
consult your dealer for information regarding an adequate grounding system.
Operation
Customer Customer Warranty Warranty
Assistance Assistance
NOTICE!
Customer
Customer
Assistance
Assistance
n a i M
Turning on Your Mobile Radio
Notice Caution Warning
Caution Warning
Turn the On-Off/Volume knob clockwise to turn
the power on and set the desired listening volume.
Customer Warranty
Assistance
To Program Radio to Country of Usage:
n o c e S
Customer
Press and hold the CH9/Normal/CH19 button.
Assistance
Turn power on to the radio.
The band ID will flash on default ID "EU" (first use only).
Turn channel selector clockwise for your ID selection.
Caution Warning
ID sequence: EU CE UK PL E1 I2
Press and release the CH9/Normal/Ch19 button again
to set and exit. The 19 DX IV EU will remember this
setting after power is turned off.
Nothing Comes Close to a Cobra
•
DE EU.
5
®
9/24/15 12:14 PM