Download Print this page

GE LOGIQ E10 Series Manual page 5

Power assistant and scan on battery

Advertisement

LOGIQ E1 0 s: Sca n on B a ttery Op tion
LOGIQ
Starting Scan on Battery-
unplugged from AC power, the system automatically
transitions to Scan on Battery mode.
Note the message in the status bar when
Scan on Battery is activated. "System is using battery
power. Make sure the battery has enough capacity
to prevent potential data loss."
Recommendation:
when possible, using the Scan on
Battery can impact battery life.
Do not use Scan on Battery mode when
you need to import/export/transfer
patient data- Using AC power is strongly
recommended in these instances.
The system can unexpectedly shut down
if the battery power is too low resulting
in patient data loss.
When the power cord is
Plug into AC power
PA
Battery Icon on
the back of the
monitor signifying
Power Assist and
Scan on Battery
Scan on
options are
Battery
available.
Switch to Power Saving Mode
The system switches to Power
Saving Mode automatically when
the capacity is low. You can switch
to Power Saving Mode by selecting
"Switch to Power-Saving Mode" in
in the battery status pop-up at any time.
Note: to return to Scan on
Battery mode, press the power
button or the freeze button.

Advertisement

loading
Need help?

Need help?

Do you have a question about the LOGIQ E10 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Logiq e10s