Table of Contents
Advertisement
24
ST11200 Family Install Guide
Drive configuration
Each disc drive has option select header connectors on
the sides and front where jumper plugs are installed to
select the way that the drive is to be configured or to
select its ID on the I/O bus.
SCSI I/O drives
On SCSI I/O drives with model numbers ending in "N"
or "ND", either J6 (on the front of the drive) or J5 (on the
side behind the SCSI I/O connector) may be used to set
the drive ID. To avoid possible incorrect ID setting, do
not use both J5 and J6 for ID selection. The following
figures show where these headers are located on the
different drives covered by this manual. There are
notes following where explanations are given about the
purpose of each jumper and specify the standard
factory (called "default") settings of these jumpers (i.e.,
settings used for most common single drive applica-
tion). Changes to these settings should be made only
if it is known that the system requires a different
configuration.
SCSI model "NC" drives do not have J5 for ID selection.
See [2] following Figures 3a and 3b.
Advertisement
Table of Contents
