Table of Contents
Advertisement
28
Jumper
Position Jumper Function Description
J2
1
Reserved for later use. Default is jumper off.
J2
2
Jumper installed in position 2 enables the
Delayed Motor Start option (if jumper in
position 3 is off). Motor start delay is 16 times
the drive ID number in seconds; i.e., drive ID
0 starts immediately, drive one starts 16
seconds later, drive ID 2 starts 32 seconds
later and etc. Default is no jumper on.
J2
3
Jumper installed enables Motor Start option.
The drive waits for the Start unit command
from the host before starting the spindle
motor. If no jumper is installed, drive opera-
tion depends on whether or not there is a
jumper in position 2. Default is no jumper on.
J2
4
Jumper installed means entire drive is write
protected. Default is no jumper on.
J2
5
Jumper installed means parity checking and
error reporting by the drive is enabled. De-
fault is no jumper on.
ST11200 Family Install Guide
Advertisement
Table of Contents
