Table of Contents
Advertisement
2.3
OC POWER: CONNECTOR J3
Do not touch the peB edge-connectors, board components or the printed cir-
cuit cable without observing static-discharge precautions. Handle the drive by
the frame only.
DC power is transmitted from the host to the drive via the power connector,
13. 13 is a 4-pin AMP "Mate-N-Lock" connector, AMP part number 350211-1,
mounted on the solder side of the PCB. The recommended mating connector
is AMP part number 1-480424-0.
Applications using cable lengths less than five feet, may use #18AWG wire and
AMP 61314-4 strip pins. For applications requiring cable lengths greater than
five feet, #14AWG wire is recommended using AMP 61117-4 strip pins.
2.4
FRAME GROUNDING: LUG J10
110 is an AMP "Faston:' part number 61761-2. It is located on the casting be-
tween and below the host/drive interface connectors. The recommended mat-
ing connector is AMP part number 62187-2. Refer below to
Figure
7.
@@@®0®0(2)
R~L<0~E
(0)
~
î
s;
~
1
FAULT
1
NO
L1FE
CONNECTION
TEST
J9
SHUNT BLOCK
(MLG-01)
J3
10
J10
J9
SHUNT BLOCK
(MLC-01)
J2
SHUNT BLOCK
(MLC-oO)
ST212 PRODUCT MANUALIRev. B
FIGURE 7:
Host/Drive Interface
and Drive Configuration
SHUNT BLOCK
(MLC-OO)
16
15
14
13
12
11
10
9
Advertisement
Table of Contents
