Table of Contents
Advertisement
19
ST11200 Family Install Guide
Initial setup information
For the initial setup connect the cables, set the SCSI
bus address and remove, install, or leave as is the SCSI
I/O line terminator resistor packs. These procedures
are described in paragraphs following.
SCSI interface cable connection
Model ST11200 family are SCSI interface drives. On
"N/ND" models, system connection is via a 50 pin,
SCSI connector. On "NC" models system connection
and DC power is via a single 80 pin SCSI connector.
Because of its shape, there is only one way the drive
can mate with the input connector. Pin 1 is noted in
Figure 2. Some cables have a contrasting color stripe
on one edge to indicate pin 1. Strain relief is recom-
mended at the cable. Do not block system cooling air
flow by the routing of cables.
Advertisement
Table of Contents
