Page 1
Use Liquid Thread Locker Washer M6 SRC Design uses Met ric System of Measu reme nt and all dimensions in Millimeters * Recommended to use the Torque specified in the table **Deno tes Usage of Liquid Thread Locker in specified Locations...
Page 2
Mounting Drawings Copyright By SRC Design and Specification are subjected to change Page 2...
Page 3
Step 1: For mounting the SRC Crash bar. remove the Thermal Shield (OE), as shown. Step 2: Unscrew the mounting Original screws in side and remove. Copyright By SRC Design and Specification are subjected to change Page 3...
Page 4
Slip-in the Bush 8x9 (4) – 1 off, Screw M6 x 20 (9) – 1 off, Bush 8x13(5)– 2 off, Screw M6 x 35 (10) – 2 off, as shown and secure the Copyright By SRC Design and Specification are subjected to change Page 4...
Page 5
Step 8: All Screws can be fully tightened to the torque, as specified in the BOM table. The installation is completed with this step. Copyright By SRC Design and Specification are subjected to change Page 5...
Page 6
Accessory part to the Vehicle. We have prepared this based on our experience and knowledge, related to the Vehicle, Part and its functional aspects. 3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s accessory part. It is advised to the User, to inspect and ensure the original state of all other Vehicle parts.