Mounting Sander; Spark Trap, Rest & Eye Shield - Grizzly G0489 Owner's Manual

Mounting Sander

This step may require three people to complete—
two to lift and hold the sander in place, and one
person to install the hardware.
Components and Hardware Needed:
Sleeve ................................................................ 1
Hex Bolt M12-1.75 X 150 ................................... 1
Hex Nut M12-1.75 .............................................. 1
Fender Washers 12mm ..................................... 2
Helpers .............................................................. 2
Angle Adjustment Lever .................................... 1
Flat Washer 12mm ............................................ 1
To mount the sander to the base:
1. Set the base in the upright position.
2.
Slide the sleeve through the holes so it spans
the width of the base yoke.
3. With the aid of a couple helpers, lift the sand-
er, spread the yoke on the sander slightly
and set onto the base (see Figure 10).
4. Slide the hex bolt and fender washers through
the sleeve and tighten the hex nut.
5.
Thread the angle adjustment lever through
the flat washer and slot and tighten the
sander in position.
Spark Trap, Rest &
Eye Shield
Theses components MUST be mounted before
operation. Refer to Figures 11-13 for assembly/
installation.
Components and Hardware Needed:
Spark Trap ......................................................... 1
Eye Shield ......................................................... 1
Rest ................................................................... 1
Rest Lever ......................................................... 1
Square Nut ........................................................ 1
Cap Screw M5-.8 x 50 ....................................... 1
-14-
Sleeve
Qty
Figure 10. Base installation.
Figure 11. Spark trap installation.
Cap Screw
Eye Shield
Qty
Figure 12. Eye shield installation.
Spark Trap
Slot
Knob
G0489 Metalworking Sander