pro.point 8348708 User Manual page 6

8348708
POWER TOOL PRECAUTIONS
1. Do not allow the tool to run without load for an extended
period of time, as this will shorten its life.
2. Do not cover the air vents. Proper cooling of the motor is
necessary to ensure normal life of the tool.
3. Avoid unintentional starting. Ensure the tool's lever (#14) is
fully extended from the tool's body when connecting to the
power source.
4. Disconnect the power source before installing or servicing
the tool.
5. After making adjustments, make sure that the adjustment
mechanisms are securely tightened.
6. Remove adjusting keys and wrenches before turning the
tool on. A wrench or a key that is left attached to a rotating
part of the tool increases the risk of personal injury.
7. Only use accessories that are specifically designed for use
with the tool. Ensure the accessory is tightly installed.
8. Only use an accessory that exceeds the No Load Speed
rating (see Specifications).
9. Never point the tool towards yourself.
10. Do not exceed the maximum 120 PSI rating (see Specifications).
11. Never use oxygen, combustible gas or any other bottled
gas as a power source. Any power source other than an
air compressor could cause an explosion and serious
personal injury.
AIR TOOL PRECAUTIONS
1. Inspect the tool's air hose for cracks, fraying or other faults
before each use. Discontinue use if the air hose is damaged or
hissing is heard from the air hose or connectors, while
operating the tool. Replace the defective component/air hose.
6
HIGH SPEED ANGLED AIR SANDER
For technical questions call 1-800-665-8685
V1.0