pro.point 8348708 User Manual page 11

V1.0
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool handles clean, dry and free from oil/grease at
all times.
6. Maintain the tool's labels and name plates. These carry
important information. If unreadable or missing, contact
Princess Auto Ltd. for replacements.
7. Replace a worn backing pad (#34) with a new one when
needed. Rotate the spindle (#31) with the included wrench
(#33) to free the backing pad. Screw a new backing pad
into place and secure the spindle with the wrench.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
CLEANING
Keep the tool clean. Wipe the tool with a clean cloth and
periodically blow out all areas with compressed air. If
compressed air is not available, use a brush to remove dust
from all areas. Do not use harsh chemicals or solvents to clean
the tool. Be sure to switch power OFF and disconnect the air
source during maintenance and inspection.
AIR TOOL LUBRICATION
NOTICE! Only use air tool oil to lubricate the tool. Other
lubricants are not suitable and will damage the tool or cause
a malfunction during use.
NOTICE! Never use a penetrating oil to lubricate an air tool.
Penetrating oil acts as a solvent that will dissolve the tool's
grease packing and may damage the o-rings, causing the tool
to seize or malfunction.
1. All air tools have an internal coating of grease to prevent
corrosion during shipping and storage. Remove this grease by
Visit www.princessauto.com for more information
HIGH SPEED ANGLED AIR SANDER 8348708
11