Steelcraft DS5 Manual

PARTS LIST:

Universal Mounting Tubes ( 85'')
2
2 Left Plastic End Caps
2 Right Plastic End Caps
4 DS5 Drop Steps
2 Front Mounting Brackets
2 Center Mounting Brackets
2 Rear Mounting Brackets
2 Front Support Brackets
4 Center & Rear Support Brackets
8 Spacers
28 T-Bolts
6 10mm x 30mm Hex Bolts
Front Mounting
Bracket
Center Mounting
(2) Universal Mounting Tubes

PROCEDURE:

REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY. ASSISTANCE IS RECOMMENDED.
1. Start installation toward the front of the Passenger/Right side of the vehicle. Locate the factory threaded
mounting hole in the bottom of the floor, (Figure 1).
2. Select the Front Support Bracket. Attach the Support Bracket to the pinch weld with (2) 6mm Hex Bolts,
(4) 6mm Flat Washers and (2) 6mm Nylon Lock Nuts. (Figure 2). Select the Front Mounting Bracket,
Attach Front Mounting Bracket to the threaded hole in the of the floor panel with (1) 8mm Hex Bolt, (1)
8mm Lock Washer and (1) 8mm Flat Washer, (Figure 3). Attach the Support Bracket to the Mounting
Bracket with (1) 10mm Hex Bolt, (2) 10mm Flat Washers and (1) 10mm Nylon Lock Nut, (Figures 3).
Do not tighten hardware
3. Move to the #2 center location, (Figure 5). Repeat Steps 2 to attach the Center Mounting Bracket and
the Center & Rear Support Bracket, (Figures 5—6).
4. Move to the rear location, (Figure 7). Repeat Steps 2 to attach the Rear Mounting Bracket and the
Center & Rear Support Bracket to the rear location. (Figures 7—8)
(2) Front Support Brackets
(4) Center & Rear Support Brackets
Rear Mounting
Bracket
Bracket
6 10mm Nylon Lock Nuts
12 10mm x 24mm x 2.2mm Flat Washers
16 8mm Nylon Lock Nuts
6 8mm x 35mm Hex Bolts
12 8mm Hex Nuts
6 8mm x 28mm x 3mm Flat Washers
12 8mm x 24mm x 2mm Flat Washers
18 8mm Lock Washers
12 6mm Nylon Lock Nuts
12 6mm x 25mm Hex Bolts
24 6mm x 22mm x 2mm Flat Washers
Rear Mounting
Bracket
(4) DS5 Drop Steps
Page 1 of 5
DS5 RUNNING BOARD
20-22 Gladiator
Front Mounting
Bracket
Center Mounting
Bracket
5/20/22 (SL)