Steelcraft DS5 Quick Start Manual

PARTS LIST:

2 Universal Mounting Tubes ( 53'')
2 DS5 Drop Steps
2 Left Plastic End Caps
2 Right Plastic End Caps
2 Front Mounting Brackets
2 Rear Mounting Brackets
2 Front Support Brackets
2 Rear Support Bracket
4 Spacer
16 8-1.25mm x 25mm T-Bolts
8 10mm x 24mm x 2.2mm Flat Washers
(2) Universal Mounting Tubes

PROCEDURE:

REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY. ASSISTANCE IS RECOMMENDED.
1. Start installation toward the front of the Passenger/Right side of the vehicle and find the front threaded
insert located in between the first pair of holes along the pinch weld
2. Next, select the Front Support Bracket,
(2) 6mm Hex Bolts, (4) 6mm Flat Washers and (2) 6mm Nylon Lock Nuts,
Mounting Bracket
8mm Lock Washer and (1) 8mm Flat Washer,
Bracket to the Mounting Bracket with (1) 10mm Hex Bolt, (2) 10mm Flat Washers and (1) 10mm Nylon
(Figure 3)
Lock Nut,
3.
Move to the rear mounting location and locate the threaded insert and pair of holes on the pinch weld,
(Figure 4).
Repeat
4. Select the Universal Mounting Tube. Select (4) 8mm T-bolts. Insert the T-bolts into the rear and bottom
channels of the Universal Mounting Tube, (Figure 7). Guide the T-bolts to the general position of the
Mounting Brackets.
5. Take (4) 8mm T-bolts. Insert the T-bolts into the front channels of the Universal Mounting Tube (Figure
8). Each front channel should have (2) T-bolts, which corresponds to the holes on the DS5 Drop Steps.
(2) Front Support Brackets
(2) Rear Support Brackets
(2) Front Mounting Brackets
(2) Rear Mounting Brackets
(Figure 2).
, (Figure 3).
Attach the Bracket to the threaded insert usin g (1) 8mm Hex Bolt, (1)
Step 2
to install the Rear Brackets.
4 10-1.5mm x 30mm Hex Bolts
4 10-1.5mm Nylon Lock Nuts
8 8-1.25mm Hex Nuts
8 8-1.25mm Nylon Lock Nuts
4 8-1.25mm x 35mm Hex Bolts
4 8mm x 28mm x 3mm Flat Washers
8 8mm x 24mm x 2mm Flat Washers
12 8mm Lock Washers
8 6-1.00mm Nylon Lock Nuts
8 6-1.00mm x 25mm Hex Bolts
16 6mm x 22mm x 2mm Flat Washers
(2) DS5 Drop Steps
Attach the Support Bracket to the pinch weld with
(Figure 3).
Do not tighten hardware. Attach the Support
(Figure
Page 1 of 5
DS5 RUNNING BOARD
18-22 Wrangler JL 2 Door
, (Figure 1).
(Figure 2).
Select the Front
)
5—6
5/18/22 (SL)