Compaq Prosignia 190 Maintenance And Service Manual page 124

inserted.
Computer beeps only
once when a PC Card is
inserted.
Network PC Card does
not work.
Storage PC Card does
not work.
Speakers are turned
off or volume is
turned down.
PC Card or card
driver is not PCMCIA
compliant.
The computer beeps
once to indicate that
a PC Card is
recognized but not
properly configured.
Necessary drivers
are not installed
(turned on).
PC Card is not fully
inserted or is upside
down.
Network PC Card or
driver is not PCMCIA
compliant.
SRAM and flash
memory PC Cards
require the memory
card driver to be
loaded.
You are trying to
access the storage
PC Card using the
wrong drive letter.
Ensure that the PC Card is
inserted in the correct
orientation. Insert the card gently
to prevent damage to the pins.
Adjust the volume control on the
computer.
Contact your Compaq authorized
dealer, reseller, or service
provider for a list of PC Cards
tested successfully in Compaq PC
Card platforms.
Before a new PC Card can be
used, it may be necessary to
perform an initial setup
procedure. Follow the PC Card
manufacturer's instructions for
formatting a hard drive card or
installing PC Card-specific drivers
for a network card.
Refer to the instructions that
came with the PC Card or contact
the vendor for information on
installing the correct drivers.
Ensure the PC Card is inserted
correctly.
Contact your Compaq authorized
dealer, reseller, or service
provider for a list of PC Cards
tested successfully in Compaq PC
Card platforms.
Memory cards can only be
accessed using DOS real mode
drivers.
If you are running Windows
95, change the drive letter
assignment in Device
Manager.
If you are running Windows
NT 4.0, change the drive
letter assignment through
the Control Panel.