Epson PictureMate Show PM 300 User Manual page 70

4
Push in the battery holder until it clicks into place.
Printing and Operation Problems
If you have problems with PictureMate, check the
suggestions on the following pages. You can also press
the button on the remote control for
troubleshooting help.
The power light and screen don't turn on.
● Press the P On button on PictureMate's side to
turn it on. (You can only use the P On button on
the remote control when the power light is
orange.)
● Make sure the power cable and AC adapter are
securely connected at both ends.
●
Make sure your power outlet works and is not
controlled by a wall switch or timer.
70
The screen goes blank or the printer shuts off
automatically.
If Auto Power Settings are in effect, PictureMate will
shut off automatically at the selected time. Press the
P On button on the printer's side to turn it back on.
The power light is orange.
This indicates that PictureMate is in standby mode.
You can turn it on by pressing the P On button on the
remote control or on the printer itself.
A slideshow appears automatically.
If the remote control has not been used for about 3
minutes, a slideshow plays automatically. Press any
button on the remote control to return to the previous
menu or screen.
PictureMate is on, but nothing prints.
●
If you're printing from your computer, make sure
the USB cable is connected securely at both ends
and the cable meets the requirements listed in
"System Requirements" on page 82.
●
If you're printing on a network, see "Set Up
Network Printing" on page 78.