Replacing Printer Parts (continued)
6
Carefully remove the cutter.
Warning:
The blade is sharp. Be careful when
removing it.
7
Insert the new cutter. Make sure the cutter pin goes
into the hole.
8
Tighten the screw using a cross-head screwdriver.
9
Align the cutter cover, then press it in until it snaps
into place.
10
Press OK to fi nish the replacement procedure. The
cutter moves back to the home position.
Replacing the Maintenance Tank
The Pro 7700 has one maintenance tank (on the right
side) and the Pro 9700 has two (one on either side).
You need to replace the maintenance tank
(part # C12C890501) when the LCD panel instructs you
to do so.
1
If you have the Pro 9700, check the LCD to
determine which tank needs to be replaced (left
or right).
Note:
The printer will not print if one of the
maintenance tanks is full. On the Pro 9700, the right
tank is used more than the left. To maximize tank life,
you can switch the tanks.
2
Turn off the printer.
3
Pull out the maintenance tank as shown.
Caution:
Do not tip the tank or ink may spill out.
4
Place the used tank in the plastic bag included with
the new tank and dispose of it carefully.
5
Insert the new tank.
8