Alto TrueMix 800FX User Manual page 10

8. Channel Pan: Turn this knob to adjust the (mono)
channel's Left-Right position in the stereo field.
9. Peak LED: This LED will flash when the signal is clipping. If
this happens, decrease the level on the Gain knob or
Channel Volume knob.
10. Channel Volume: Turn this knob to adjust the level of the
channel's output signal.
11. Control Room Outputs: Use 1/4" (6.35 mm) TRS cables to
connect these outputs to your monitor or amplifier
system. The level of these outputs is controlled by the
Control Room/Headphone Output knob.
12. Main Outputs: Use 1/4" (6.35 mm) TRS cables to connect these outputs to a
speaker or amplifier system. The level of these outputs is controlled by the Main
Out Volume knob.
13. MON Send Output: Use a 1/4" (6.35 mm) TRS cable to connect the Mon Send
output to the input of an external amplifier or active monitor to create a custom
monitor mix for onstage musicians. You can adjust the signal volume (pre-EQ)
for each channel in this mix using the MON volume knobs.
14. EFX Send Output: Use a 1/4" (6.35 mm) TRS cable to connect the EFX Send
output to the input of an external effects module. You can adjust the signal
volume (post-EQ) for each channel in this mix using the EFX volume knobs.
15. Return Inputs: Connect the outputs of an external device to these inputs with
standard 1/4" (6.35 mm) cables. The Return is commonly used for outboard
effects devices but can also be used like an extra input channel for synthesizers,
drum machines, etc. If your source is mono, plug it into the Left input and it will
be heard on both the left and right sides. The level of these inputs is controlled
by the Return (TO MON) volume knob. When a device is connected to the 1/4"
TRS Return inputs, the on-board EFX are disabled. The EFX Return (to MAIN)
knob will route the signal of the return inputs to the MAIN mix.
16. Return (TO MON): Turn this knob to adjust the level of the signal sent from the
Return Inputs to the Mon Output.
17. 2-Track/USB Inputs: You may connect these inputs to
the outputs of an external sound source using a
standard stereo RCA cable (sold separately). You can
also send this channel to the headphone mix (using the
Headphone Source button) and/or the main mix
(using the 2-Track/USB To Main Out button).
18. 2-Track/USB
outputs to the inputs of an external recording device
using a standard stereo RCA cable (sold separately).
19. 2-Track/USB To Main Out: Press this button to send the 2-Track/USB Input
signal through the Main Outputs.
20. 2-Track/USB Input Volume: Turn this knob to adjust the volume of your
2-Track/USB In signal.
10
Outputs: You may connect these