Neilsen CT4794 Quick Start Manual

PNEUMATIC DENT PULLER SLIDE HAMMER
Technical Data
Air Inlet: 1/4"
Avg. Air Consumption.: 113L/min
Working Pressure: 6.3 - Bar
Suction Head Ø: 60 - 120 - 150 mm
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLYAND WITH CARE
FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP

1. Safety Instructions

WARNING!
Ensure Health & Safety, local authority and general workshop practice regulations are adhered to
when using thisequipment.
WARNING!
Disconnect from air supply before changing suction cups, servicing or performing any maintenance.
• Maintain the puller in good condition (use an authorised service agent).
• Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
• Use in a suitable work area. Keep area free from unrelated materials and ensure that there is
adequate lighting.
• Before each use check condition of tool. If any component is worn or damaged replace
immediately.
WARNING!
Always wear approved eye (or face) and hand protection when operating the puller.
• Remove ill fitting clothing. Remove ties, watches, rings, other loose jewellery and contain and/or
tie back long hair.
• Wear appropriate protective clothing and keep hands and body clear of working parts.
• Maintain correct balance and footing. Do not over reach, ensure the floor is not slippery, wear
non-slip shoes.
• Keep children and unauthorised persons away from the working area.
• Ensure workpiece is secure before operating the puller.
(90 - 1 0 PSI)
INSTRUCTIONS SAFE FOR FUTURE USE.
CT4794
IMPORTANT:
60 mm
120 mm
150 mm