Ekip Connect 3 Provisioning Steps - ABB E-Hub 2.0 Getting Started

7 E - H U B 2 . 0 G E T T I N G S TA R T E D
—
Ekip Connect 3
Provisioning Steps
E-Hub 2.0 Connect
Configure the Ethernet option in the "Scan"
section and press "SCAN" as shown by pointer to
discover E-Hub 2.0.
Edit Tag Name
Click the "Information" section and edit device tag
name as shown by the pointer.
Click save after edit the device tag name.
E-Hub 2.0 Communication – To Internet – ETH0
Follow the next instructions if you want to
connect the E-Hub 2.0 to internet through the
ETH0. Be sure that the E-Hub 2.0 ETH0 port is
connected to internet via an ethernet cable.
Click the "Connectivity" tab then select "To
Internet" and click on the "Ethernet 0" tile.
Configure the parameters according to the
network where ETH0 is connected, for example
you can force a static IP address.