Declaration Of Conformity - Jaga BRIZA 12-JFCC Manual

2.3. CIRCUIT BOARD ERROR CODE
RS485 A/B I2C
PC / RF CO2
POWER 45W
INPUT: 110-240VAC
OUTPUT: 24V
Tsens 1
CONTROL PANEL
Tsens 2
Tsens 3
THERMOSTATE 1
ON
Tsens 4
1 2 3 4 5 6 7 8
GND 0-10V 24V
GND 24V
DIPSWITCH
JAGA
GND 24V
GND NTC1 GND 0-10V +24V +24V RC GND IN/OUT GND 0-10V V.H.
2.4. FACTORY RESET
RS485 A/B I2C
[B
PC / RF CO2
POWER 45W
INPUT: 110-240VAC
OUTPUT: 24V
Tsens 1 T
CONTROL PANEL CONTROL PANEL
Ts Tsens 2
THERMOSTATE 1 MOSTATE 1 Tsens 3 Tse
ON
Tsen Tsens 4
N L
GND 0-10V 24V 1 2 3 4 5 6 7 7 8 8
GND 24V
DIPSWITCH WITCH
JAGA JAGA
GND 24V
GND NTC1 GND 0-10V +24V +24V RC GND IN/OUT UT GND GND 0-10V 0-10V V.H. V.H. GND GND 0-10V 0 V.C.
3. DECLARATION OF CONFORMITY

DECLARATION OF CONFORMITY

CEO JAGA N.V.
JAGA N.V. - Verbindingslaan 16 - B 3590, declares under its sole responsibility that the
Jan Kriekels
product to which this declaration relates:
is in conformity with the following standards or documents provided that these are used in accordance with our
instructions:
A14:2010 + A15:2011 / NBN EN 60335-2-80 BASED ON EN 60335-2-80:2003 + A1:2004 + A2:2009
Following the provision of Directives as amended:
- Low Voltage 2014/35/EC
- EMC 2014/30/EC
- Machinery 2006/42/EC
08/02/2022
- RoHS 2011/65/EU
JAGA NV | BRIZA 12 - JFCC | MANUEL | 2023.03.06 | V.5.2
Error sensor [B]/[C] - Check the water temperature sensor
Error sensor [J] - Check the room temperature sensor
[B]
[C]
N L
GND 0-10V V.C.
1. Disable power charge .
2. Press and hold down both the [-] and [+] button on the circuit board and switch on the
power again. The blue LED will light up, followed by the green LED 2 seconds later and
the red LED 4 seconds later. Release the buttons as soon as all 3 LEDs are flashing .
3. The controller will return to the Factory Default settings, all LEDs will flash for 8 seconds .
NBN EN60335-1 BASED ON EN60335-1-2002 + A11:2004 + A1:2004 + A12:2006 + A2:2006 + A13:2008 +
MODE 1 2 3
MODE 1 2 3
BRIZA 12, BRIZA 22, BRIZA 26
EN
53