- 10V Bms With Water- And Room Temperature Monitoring; (Auto-Change-Over) - Jaga BRIZA 12-JFCC Manual

B. 0 - 10V BMS WITH WATER- AND ROOM TEMPERATURE MONITORING

(AUTO-CHANGE-OVER)

Configuration code : FCC.BRC42 / FCC.BRC62 / FCC.BRC64
Only in combination with a suitable heat
pump and control valve for heating and
cooling
2⁰C
The device automatically enters cooling mode when the water temperature is 2
the differential between room and water temperature is less than 1
The unit is in standby. The unit automatically starts a new cycle if the preset temperature is reached.
The device automatically enters heating mode when the water temperature is 4
If the differential between room and water temperature is less than 1
device will automatically switch to standby.
MODE
[F]
RS485 A/B I2C
PC / RF CO2
ON
GND 0-10V 24V
GND 24V
GND
GND NTC1 GND 0-10V +24V
[I]
44
1⁰C
POWER 45W
INPUT: 110-240VAC
OUTPUT: 24V
Tsens 1
CONTROL PANEL
Tsens 2
Tsens 3
THERMOSTATE 1
Tsens 4
N L
1 2 3 4 5 6 7 8
DIPSWITCH
JAGA
24V
+24V RC GND IN/OUT GND 0-10V V.H. GND 0-10V V.C.
[H]
[A]
(230V
strain relief
Standby mode
°
C/2°F, the device will automatically switch to standby.
° C/2°F higher than the room temperature, the
MODE
[F]
2-pipe
[C]
[D]
[I]
- 50Hz)
JAGA NV | BRIZA 12 - JFCC | MANUEL | 2023.03.06 | V.5.2
1⁰C
°
C/4°F below the room temperature. If
° C/7°F above the room temperature.
RS485 A/B I2C
PC / RF CO2
POWER 45W
INPUT: 110-240VAC
OUTPUT: 24V
Tsens 1
CONTROL PANEL
Tsens 2
Tsens 3
THERMOSTATE 1
ON
Tsens 4
N L
1 2 3 4 5 6 7 8
GND 0-10V 24V
GND 24V
DIPSWITCH
JAGA
GND 24V
GND NTC1 GND 0-10V +24V +24V RC GND IN/OUT GND 0-10V V.H. GND 0-10V
[G] [H]
strain relief
4⁰C
4-pipe
[B]
4-pipe
[C]
[D]
V.C.
[A]
(230V - 50Hz)