12. MAINTENANCE ......................18 13. WARRANTY ....................... 19 14. DISSASSEMBLY INSTRUCTIONS ............... 19 DECLARATION OF CONFORMITY JAGA N.V. - Verbindingslaan 16 - B 3590, declares under its sole responsibility that the product to which this declaration relates: CEO JAGA N.V. BRIZA 12, BRIZA 22...
USED SYMBOLS 1. the DANGER sign warns the operator and maintenance staff about risks that may cause death, physical injury or illnesses of any kind. DANGER: ELECTRICAL HAZARD DANGER: SHARP EDGES DANGER: HOT SURFACES DANGER: MOVING PARTS ATTENTION: IMPORTANT WARNING the ENVIROMENTAL SAFEGUARD sign provides instructions on how to use the unit in an ECO-friendly manner.
2. WARNINGS AND SAFETY Handling guidelines: The unit must be handled with care in order to avoid damage to the unit’s interior and exterior parts. The unit might have sharp edges; use gloves during installation/adjustment. All the operations listed below must be carried out in accordance with local health and safety regula- tions.
– it is advisable to run the unit at maximum speed and to check for abnormalities. Operational limits: An installation that does not meet the specified operational limits releases Jaga NV from all liability with respect to damage to objects or people.
10. OPERATING LIMITS If the appliance is supplied with chilled water, the condensation forming on the heat exchanger will be drained via the condensation drain connection. At very low chilled water temperature and very high humidity, condensation may form on compo- nents other than the heat exchanger.
Page 13
10.2. HYDRAULIC CONNECTION It is very important for the water connections to be installed with care by qualified personnel. Wall Ceiling Connect the unit to the hydraulic system with the indicated inlet/outlet connections. Make sure the connections are air tight with a sealant. All heat exchangers (including the additional one) are equipped with an air vent near the top connection and a water drain near the lower connection.
Page 14
The electrical connection of the unit must be carried out by qualified personnel, in compliance with the regulations applicable in the country where the unit is installed. Non-conforming electrical con- nections releases Jaga N.V. from liability concerning damage to objects and persons. DANGER! – ...
Page 15
10.4. FILTER REPLACEMENT MODEL 8721.401 8721.402 8721.403 8721.404 8721.405 8721.406 CODE Wall Ceiling Remove the screw and open the locks on the side of the device. Take the filter out of the unit. Place a the new filter in the unit. Wall Ceiling Relock the filter by turning the locks and replace the screw.
11. INITIAL START IMPORTANT! Start-up and Commissioning of the fancoil must be carried out by skilled staff, qualified to work on this type of product. DANGER! Before start-up, make sure the installation has been carried out in compliance with in this manual. Before start-up the fancoil unit, check if: 1.
12. MAINTENANCE DANGER! – maintenance must be carried out by qualified technicians. – do not insert sharp objects into the supply and return grilles – the unit has sharp edges; use gloves during maintenance! DANGER! Always use the main disconnect switch to isolate the unit from the mains before carrying out any maintenance or inspection work.
– the fan coil has not been periodically cleaned, – the unit has been used in an improper or irresponsible manner, – repairs have been carried out by others than Jaga, – product modifications have been carried out by others, before or after the installation, – ...
Need help?
Do you have a question about the Briza 22 Series and is the answer not in the manual?
Questions and answers