Epson Stylus Pro 11880 Unpacking And Setup Manual page 9

4. Plug the cable connector into the connector on
the back of the printer as shown below, then
tighten the screws on both sides of the
connector.
5. Turn the lock lever to the left to release it.
6. While holding the movable unit, attach the
movable unit stopper on the bottom of the
movable unit. Snap the two protrusions of the
stopper into the movable unit, so the stopper
does not fall off. Tighten the two screws to
attach the movable unit to the horizontal strut.
7. Attach the flange (marked with L) on the
movable unit by pinching the knob.
The flange is reversible. One side is for the
3-inch core, and the other side is for the 2-inch
core. Set the appropriate side for the core.
8. Attach the reflector on the back of the left base
unit, and then tighten the two screws.
7