Epson Stylus Pro 11880 Unpacking And Setup Manual page 21

Printing on thick paper (0.5 to
1.5 mm)
When you load thick cut sheets (0.5 to 1.5 mm),
such as cardboard, follow the steps below.
Note:
Do not load thick paper (0.5 to 1.5 mm) longer than
728 mm; otherwise, paper jams may occur.
1. Make sure that the printer is on and the roll
paper cover is closed.
2. Press the Paper Source
until Sheet appears.
3. Make sure that the Paper Check light is on,
and then set the paper lever to the released
position. LEVER RELEASED. LOAD PAPER
appears on the LCD panel.
The paper lever may be locked if REMAINING
PPR SETUP is set to ON: AT ROLL EXCHANGE. In
this case, press and hold the Enter
for 3 seconds to print the barcode, so you can
release the paper lever.
c
Caution:
Do not set the paper lever to the released
position while the Power light or Pause light
is flashing; otherwise, damage may occur.
button repeatedly
button
4. Open the front cover.
c Caution:
Be careful not to touch the cables around the
print head ; otherwise, the printer may be
damaged.
5. Load the sheet into the paper insertion slot so
that the bottom edge of the paper rests behind
the open front cover.
Make sure that the right and bottom edges of
the sheet are straight and in line with the
vertical line.
Note:
Load the sheet vertically, like most magazines.
19