Loading Envelopes - Epson WorkForce Pro WP-4595 DNF User Manual

WP-4511/4515/4521/4525/4530/4531/4535/4540/4545/4590/4595
F
Slide the edge guide to the edge of the paper, but not too tightly.
Note:
❏ After loading paper, set paper size for each paper source. Paper will be fed from appropriate paper source based
on setting. To set paper size, press Setup. Then select Printer Setup and Paper Size Loaded.
"Paper Size Loaded" on page 117
&
❏ You can also use the panel utility to set the paper size.
"Paper Size Loaded Setting" on page 145
&
❏ For fax capable models, you can select which paper source(s) to feed paper from in Paper Source to Print.
"Selecting paper source to print fax" on page 106
&
❏ For plain paper, do not load paper above the line just under the d arrow mark inside the edge guide. For Epson
special media, make sure the number of sheets is less than the limit specified for the media.
"Selecting which tray to use and its loading capacities" on page 25
&
❏ Up to 1 sheet of Legal-size paper can be loaded at a time.

Loading Envelopes

Follow these steps to load envelopes:
Note:
The illustrations in this section are from a similar product model. Although they may differ from your actual product, the
method of operation is the same.
A
Slide out the output tray, and raise the stopper.
User's Guide
Paper Handling
33