Cebora SYNSTAR TRIPLE 200M Instruction Manual page 33

• Soft Start AUTO
Adjustment can vary from 0 to 100%. This is the wire speed expressed in percentage of the speed set for welding,
before the wire touches the workpiece to be welded.
This adjustment is important to always obtain good starts.
The manufacturer adjustment is Auto (Default function)
To access this function, simply highlight it using the knob B and press it for less than 2 seconds. The display screen
A shows the adjustment bar. The figure can be changed and confirmed by pressing the knob B for less than 2 sec-
onds.
• Pre-Flow
Adjustment ranges from 0 to 10 seconds.
To access this function, simply highlight it using the knob B and press it for less than 2 seconds. The display screen
A shows the adjustment bar. The figure can be changed and confirmed by pressing the knob B for less than 2
seconds.
• Post-Flow
Adjustment ranges from 0 to 25 seconds.
To access this function, simply highlight it using the knob B and press it for less than 2 seconds. The display screen
A shows the adjustment bar. The figure can be changed and confirmed by pressing the knob B for less than 2
seconds.
• Units
Choosing between metric and imperial systems.
3301278
33/37