Description Of The Panel - Mains MV4k/1 Instructions Manual

Controller MV4K - description of the panel
Digital programmable belt controller
Buttons:
1. Turning on or off the conveyor belt in automatic mode with the use of photocells.
2. Turning on the operation belt mode, controlled with the use of the footswitch.
3. Switching L1 circuit (first pressing - continuous signal, second pressing - intermittent signal).
4. Safety switch - disconnects the power supply terminal phase
.
STOP – in case of any emergency, you must press the button!
This will immediately disconnect the power supply and stop the motor.
This function is to be used only in emergency situations!
5. Main power switch – turns on the power of the controller and the circuit of the lamp 2
LEDs:
SERVICE – signals the need to service review of the unit.
- indicates the activation of the elevation motor cover sensor.
S.START – indicates that the motor soft start function is turned on
.
OUT – indicates the type of applied voltage for additional output - either continuous or intermittent.
CTRL – indicates motor operation.
MAINS S.C. E.M.Wosińscy Brzeziny 95-060 ul. Słowackiego 12, tel/fax: 48 46 8752 777 www.mains.pl; mains@mains.pl
1 2
Front panel of the MV4K
3
SERVICE
S. START
2
OUT
CTRL

Description of the panel

4 5
Mv4k
POWER POWER
controller: Mv4k 11